Make a 9V headlamp head flashlight

Here’s an easy project that simple enough for electronic beginners, plus the supplies required are probably laying around your house or workshop.

Could you buy the same thing for just a few dollars more? Sure you could, but you’d miss out on the satisfaction of assembling this project all by yourself.

Here’s what you need:
2 high intensity white LEDS (you can use other colors if desired)
small perf board
2 470 ohm resistors
toggle switch or slide switch
9V battery snap
9V battery
small project box (you can use an Altoid tin)
electrical wire (about 2′ total)
soldering iron
solder
hot glue
electrical tape

For full assembly instructions, you can view the pages here:
http://www.instructables.com/id/9-Volt-Headlamp/