Tag Archives: Metal Film Resistors

Learn about metal film resistors

Resistors are a common passive item in any electronic assembly. They are used for restricting the amount of current flowing in a circuit; acting much as a valve does in a water pipeline. The most commonly in use are carbon, thick metal and thin metal film resistors. The film forms the resistive material of the resistor.

The axial resistor is usually a cylindrical conductive film on a non-conductive ceramic carrier. Two leads projecting from both ends of the resistance help in connecting the item electrically within a circuit. Although the appearance of a metal film resistor is very similar to that of a carbon film resistor, the former has much better properties of stability, accuracy and reliability.

A cylindrical ceramic core of high purity forms the base of a metal film resistor. Manufacturers mostly use a method known as sputtered vacuum deposition to deposit a thin metal layer on this ceramic base. This combination is then kept at a low temperature for a long period, which results in very good accuracy for the resistor. Mostly, the resistance material used is nickel chromium (NiCr), however, for special applications, other alloys such as tin and antimony, tantalum nitride with platinum and gold are used as well.

The thickness of the metal film strongly governs the stability of the resistance. Typically, a metal thickness of 50-250nm is a good compromise between better stability and lower resistance value. For connecting to the circuit, two end caps with connecting leads are pressed on to the two ends of the resistor body.

To obtain the desired resistance a laser beam cuts a spiral slot in the thin metal layer. This is a more modern method as compared with grinding techniques and sandblasting used earlier for trimming the resistance value. Once the final value of the resistance is achieved, several layers of paint are placed on the resistor body, with each layer being baked individually.

Apart from providing a high dielectric strength, the coating protects against ingress of moisture and mechanical stresses. Color code bands on the body mark the resistor value along with the tolerance band. Metal film resistors are available with standard tolerances of 2, 1, 0.5. 0.25 and 0.1%, with the TCR or temperature coefficient of resistance lying between 50 and 100 ppm/K.

Metal film resistors demonstrate good properties for TCR, stability and tolerance. Because these resistors have a low voltage coefficient, they feature high linearity and low noise properties. Therefore, if any of your circuits need low noise, tight tolerance and low temperature coefficient properties, be sure to use metal film resistors. For example, active filters and bridge circuits use metal film resistors.

Metal film resistors show good reliability when operated from 80 percent down to 20 percent of their specified power rating. Although reliability generally increases if the resistor is derated 50 percent, going below 20 percent of the power rating at elevated humidity conditions usually diminishes reliability. Moreover, metal film resistors are more easily damaged by power overloads and voltage surges, as compared to carbon composition or wire-wound resistors.